How can I delete a portion of the info from the Title where a file has hundreds of pages? The reason is when I send the file to the subcontractor, I dont want them to view my client's info or the project info. Only the drawing is enough.
Well, I slap an empty text box over it and use a white fill. I then use "apply to pages" and flatten only the boxes. Make sure "Allow Markup Recover" is unclicked.
New to bluebeam, best way to locate stamp in a pre-determined location on a sheet?
Hello, I can't get Bluebeam review to work with handwriting to text while using it with my XpPen artist Pro 13.3. I enable the Pencil Entry (Entré de Crayon, I'am using the french version) and I cant make a single A to make it appear in text… Thanks for reading.
Suddenly, my space bar doesn't work with lower case text; just a continuous string of words. Any suggestions?
I'm working with a new firm, and they have clients who might (based on comments from other posts) not want us to use Bluebeam Studio Sessions. I'm assuming these objections that people have experienced are based on some security protocols their clients have. My question is, what are those objections? What do we need to ask…
Hi All, I am a site super who uses BB mainly for document management. As such I created a Set(.bex) to combine the different divisions of my project for easy access. I don't change anything on any of the documents but each time I close down BB a window pops up asking if I want to save the changes made to my Set(.bex) file.…
Can I change blend mode - use transparency, and color with overlay layers? I am not able to manipulate. I want one layer bright and other reduced opacity.
When I add new drawings to my Set the old, superceeded pages are not being crossed out. It appears that the new pages are assigned the correct revision number and all the sheet names and numbers are the same but they are being treated as all current revisions. I am new to Sets and have yet to make the feature work. I…
Currently I add each open file to an open session by "right click - Add to open Studio Session". Is there a way to batch this process? This would save me a lot of time.
Hello peers, My goal using BB is to create excel spreadsheets of the counts of Exhaust Fans, Grilles, equipment etc. But most importantly ductwork. Instead of using the measurement tool where it gives you red measurements inbetween two arrows, is there a way I can highlight the duct run and it store the measurement?…
I would like to know how could I clip a snapshot of a plan and drop it on a sheet with an elevation, then rotate the plan 180 to compare to the elevation?
