Hello
I'm trying to scale this drawing with the top measurement. It needs a . after the 13, separating the millimeters, put Blue beam does not allow it
sorry, for sending the question again and I've sorted it out. my blue beam is set on ,'s.
I changed a lot of my tool sets and the , to a ., but is was not saved, where van I activate the auto save, I did checked the drawing in and sved it, before closing it
I think your scale is off. 13,000 m is 13KM, not really something you ever see on a drawing.
Thank you, my blue beam is set on ,, therefore when I tried to separate with a ., it did not register
