Break a linear markup into segments?

Ty Keith
Ty Keith Posts: 5
in Peer Support

We use a linear markup tool to draw electrical conduit routing. But there are sections of the conduit run that are PVC, sections that are EMT, and sections that are GRC… (different conduit types). It would be great if we could use the one tool to draw out the entire run, then break that run into sections for the different conduit types. Ultimately, we need a footage of PVC, footage of EMT and footage of GRC for that conduit run.

Is this possible, how?

Answers

  • Jim C
    Jim C Posts: 2

    Ty,

    Simplest method here is to run a single polylength, then right-click on it and use the SPLIT or SPLIT all tool to break segments or the entire lenght. From there, just change the LABEL to the type of product you're tracking (PVC/EMT) to get the result totaled. Hope that helps!

    Jim Coppinger

    Zentek Consultants

    www.zentekconsultants.net

Categories