Default Precision in Calibration and Measurement Tool

Kenneth Kennedy
Kenneth Kennedy Posts: 1
in Product Ideas & Feedback

It would be very helpful if Bluebeam would allow a default setting, or remember the last setting used, when using the measurement tool. As of now, when I calibrate, I have to also select the precision to 1/16" instead of the default 1/4".

5
Up
5 votes

Active · Last Updated

Comments

  • Geert Brouwers
    Geert Brouwers Posts: 1

    same here.

    I want to change this default value to 0 instead 0,01 (metric system). It irritates me to have to adjust this every time

  • Mark Gay
    Mark Gay Posts: 1

    Yes, I need to change the default precision from 1/4" to 1"….this wastes so much time and the extra fractions clutter up the take off…. for what we are measuring, 1" precision is all we need… Is there a solution to this challenge?

Categories