PDF Creation from Autodesk Inventor to Bluebeam

Karel

Primarily, I use Autodesk Inventor from modeling to the Drawing.

When I decide to print a drawing, I use the Bluebeam driver …

From there, I go to Properties …

and then on to Advanced …

Here is where it becomes interesting …

Within my Drawing Set, I have only 2 sizes of sheets, Tabloid ( 17"x11" ) and Letter (8.5"x11").

As it stands, I have to create 2 print jobs for my Drawing, 1 for Tabloid and 1 for Letter size.

I would really like it if there was an auto-detect variable instead of choosing one or the other so I did not have to combine the 2 different sizes using Bluebeam.

Thanks in advance for your time … I could really use some good news 😉