Add Average to the Totals When Grouping Measurements

MERICA

I use the Polylength tool to measure cable runs while taking off drawings during bidding. I assign a specific color line to whatever outlet type I am counting like a 2-postion or 2-cable outlet as an example. I then take off the lengths of all 2-pos outlets per drawing(s). I then group them and figure the average by using the totals (total length & line count) drop down box to get the average. It would save some calculator work and time if the average was shown in the totals drop down box. This system I developed works well because I am able to check the line count against my outlet counts for a more accurate take and documentation to refer back too.